Enabling The Vlan Function - Huawei espace 7810 Administrator's Manual

Huawei IP Phone eSpace
7810&7820&7830&7850&7870&7803X
Administrator Guide
Table 2-6 PC port parameters
Parameter
As Bridge
As Router
-IP Address
-Subnet Mask
-Enable DHCP Server
-Start IP Address
-End IP Address

2.3.3 Enabling the VLAN Function

Function Description
A VLAN is a group of hosts with a common set of requirements that communicate as if they
were attached to the same broadcast domain, regardless of their physical location. VLANs are
mainly configured on switches and routes. Broadcast traffic and unicast traffic on a VLAN
cannot be forwarded to other VLANs, which controls traffic, simplifies network management,
and reduces broadcasts.
If the VLAN function is enabled on an IP phone, the IP phone can communicate only with
computers on the same VLAN.
Phone Configuration
Set VLAN parameters in the Advanced area on the Network tab page, as shown in
2-8.
Issue 01 (2011-12-31)
Description
If you select As Bridge, the PC port functions as a bridge.
If you select As Router, eSpace 7850 functions as a router.
IP address of an IP phone when it functions as a router.
Subnet mask for the IP address of an IP phone when it
functions as a router.
Indicates whether to enable the DHCP function for eSpace
7850.
Start IP address assigned to the device connected to the PC
port when the DHCP function is enabled for eSpace 7850.
End IP address assigned to the device connected to the PC
port when the DHCP function is enabled for eSpace 7850.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Single IP Phone Configuration
Figure
18