Shooting Techniques For Different Targets; Low Angle Recording; Zebra Pattern - Panasonic AG-3DA1E Operating Instructions Manual

Shooting techniques for different targets

Low angle recording

Recording can be controlled with the handle
START/STOP button during low angle recording
by moving the REC selector switch to the ON
position.
• To prevent erroneous operation when not using
the handle START/STOP button, set the REC
selector switch to the OFF position.
REC selector switch
4
Handle START/
STOP button

Zebra pattern

Press the ZEBRA button in the CAMERA mode
to show the zebra pattern on the viewfinder and
the LCD monitor so you can check the brightness
of the subject.
Parts that may be whited out through over
exposure are shown as a zebra pattern.
• Very bright
• Reflecting parts
You can remove most overexposed parts by
adjusting the iris and shutter speed in the manual
mode to remove the areas with zebra patterns.
The display changes as follows each time you
press the ZEBRA button: OFF
ZEBRA OFF ...
BARS SHUTTER
CH 1 SELECT CH 2
INT （L）
INPUT 1
INPUT 2
COUNTER
MIX
The zebra pattern you have set appears as a
percentage on the display for about  seconds.
• In the setup menus, DISPLAY SETUP screen,
ZEBRA DETECT1 and ZEBRA DETECT, set
the brightness for the zebra patterns. (Page 81)
ZEBRA1
SPEED SEL
1 INPUT 2
INT （R） ON
OFF
INPUT 2
MIC POWER +48V
AUDIO
RESET WFM
EVF DTL ZEBRA
ZEBRA button