Installing The Starter Clutch - Yamaha WR450F Owner's Service Manual

INSTALLING THE STARTER CLUTCH

EAS2GC1308
1. Install:
• Stator "1"
• Stator bolt "2"
Stator bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
LOCTITE®
• Crankshaft position sensor "3"
• Holder "4"
• Crankshaft position sensor bolt "5"
Crankshaft position sensor bolt
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
TIP
• Pass the stator coil lead between ribs "a", and
put it in part "b" so that there is no slack.
• Pass crankshaft sensor lead "c" over stator
coil lead "d".
• Pass the crankshaft sensor lead outside of rib
"a" and place the excess end next to boss "e".
• Make sure that the end surface of holder "f"
does not get caught on rib "a".
• Place the stator coil lead and crankshaft sen-
sor lead inside the U-shaped space "g"of the
holder.
• Tighten the stator bolt using the T25 bit.
• Apply the sealant to the grommet of the AC
magneto lead.
Yamaha bond No. 1215
90890-85505
(Three bond No.1215®)
GENERATOR AND STARTER CLUTCH
g
LT
a
b
a
2. Install
• Starter clutch drive gear "1"
TIP
Apply the engine oil on the starter clutch drive
gear inner circumference.
6-66
d
f
c
e