CHECKING THE PRIMARY DRIVEN GEAR
EAS2GC1276
1. Check:
• Primary driven gear
Damage/wear Replace the primary drive
and primary driven gears as a set.
Excessive noise during operation Re-
place the primary drive and primary driven
gears as a set.
INSTALLING THE OIL SEAL
EAS2GC1277
1. Install:
• Oil seal "1"
New
• Washer "2"
• Circlip "3"
New
TIP
• Apply the lithium-soap-based grease on the
oil seal lip.
• Install the oil seal in parallel with its manufac-
ture's marks or numbers facing inward.
LS
INSTALLING THE RIGHT CRANKCASE
EAS2GC1278
COVER
1. Install:
• Dowel pin "1"
• O-rings "2"
New
• Collar "3"
• Gasket "4"
New
TIP
Apply the lithium-soap-based grease on the O-
ring.
1
2. Install:
• Right crankcase cover "1"
3
2
1
4
New
LS
2
New
3
1
• Right crankcase cover bolt "2"
Right crankcase cover bolt
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
TIP
• Apply the engine oil on the impeller shaft end.
• When installing the crankcase cover onto the
crankcase, make sure that the impeller shaft
end "3" aligns with the balancer end slot "4".
• Tighten the right crankcase cover bolts in
stages and in a crisscross pattern.
INSTALLING THE CLUTCH
EAS2GC1279
1. Install:
• Push lever shaft "1"
TIP
• Apply the lithium-soap-based grease on the
oil seal lip.
• Before installation, apply the engine oil to the
push lever shaft sliding surface.
1
6-46
CLUTCH
2
1