Cub Cadet 1000 SERIES Service Manual page 44

Series 1000 and 1500
24.7. Turn-off the engine and allow it to cool before
starting to work on the tractor. To gain access to
the control linkage, perform the following three
steps:
24.8. Remove the cutting deck.
24.9. Lift and safely support the rear of the tractor.
24.10. Remove the rear wheels using a 3/4" wrench.
24.11. Move the control pedal through it's range of
travel (with the parking brake released) and look
for the following conditions that will cause loss of
linkage motion:
• Pedal loose on the pedal shaft.
• Loose arm that connects the pedal shaft to the
control rod.
• Worn bushings supporting the pedal shaft.
• Worn ferrule or an elongated hole where ferrule
connects to pedal shaft.
24.12. Disconnect the control rod from the pedal shaft
by removing the cotter pin that secures the
adjustable ferrule on the rod to the shaft.
See Figure 24.12.
Figure 24.12
24.13. Confirm that the pedal shaft moves freely in the
bushings, and does not bind.
24.14. Worn pedal shaft bushings are easily replaced
using the following 5 steps.
NOTE: It is recommended to replace all four
bushings at the same time.
24.15. Set the parking brake, and remove the drive
24.16. Remove and discard the cotter pins that hold the
Cotter pins
Adjustable
ferrule
40
pedal using a T-40 driver. See Figure 24.15.
T-40 Screws
Figure 24.15
inboard bushing in place on both the speed con-
trol assembly and the brake control assembly.
See Figure 24.16.
Figure 24.16