Microwave Drawer Assembly Removal To Access Oven Components; Oven Component Removal - Sharp KB-3425LS Service Manual

KB-3425LS/K/W
KB-4425LS/K/W
4. Remove screws from Microwave top Air Duct and take off (Fig. 7).
5. Remove all screws from Microwave Back Plate (Fig. 7).
6. Lift Back Plate and remove carefully not to damage any wires (Fig. 7).
NOTE:
The Microwave Back Plate cannot be
completely removed due to wiring. If you
need to remove, you will have to unhook all
wiring routed through it.
Also, the cushion placement is very impor-
tant and must be replaced if damaged during
removal (Fig. 8).
Fig. 8
At this point, you will have access to all parts of the Microwave and Oven.

MICROWAVE DRAWER ASSEMBLY REMOVAL TO ACCESS OVEN COMPONENTS

OVEN COMPONENT REMOVAL

. After dissaembly as previously stated, remove Microwave Drawer assembly by removing (2) screws (right & left) from
front of Microwave Baseplate (Fig. R-1).
2. Unhook wires from Range Oven to Microwave Drawer, remove Drawer assembly from Oven.
You now have access to Range Oven components.
Fig. R-1
42
Fig. 7
Air Duct
Back Plate
screw