Toro 30410 Operator's Manual page 43

Test Port "B" (Fig. 59), located on the right side of the
machine, is used to measure the reverse traction pressure.
Figure 59
1. Test port "B"
Test Port "C" (Fig. 60), located on the left side of the
machine, is used to measure the left cutting unit pressure.
Figure 60
1. Test port "C"
Test Port "D" (Fig. 61), located on the right side of the
machine, is used to measure the right cutting unit pressure.
1
1
43
1
Figure 61
1. Test port "D"
Test Port "E" (Fig. 62), located under the radiator, is used
to measure the four-wheel drive pressure in reverse.
Figure 62
1. Test port "E"
1