Table of Contents
Advertisement
Setup
Note: Determine the left and right sides of the machine from the normal operating position.
Loose Parts
Note: Use this chart as a checklist to ensure that all parts necessary for assembly have been received. Without these parts,
total setup cannot be completed. Some parts may have already been assembled at the factory.
Description
Seat belt
Capscrew
Washer
Manual tube
R-clamp
EEC decals
EEC certificate
Parts catalog
Pre-delivery inspection sheet
Operator's manual
Engine manual
Operator Video
Registration card
Installing the Seat, Seat Belt,
and Manual Tube
The machine is shipped without the seat assembly. Deluxe
Seat Kit, Model No. 30398, and Seat Suspension Kit,
Model No. 30396, must be purchased and installed.
1. Mount the manual tube to the seat suspension with the 2
R-clamps included in loose parts.
2. Install the seat belt to each side of the seat with a bolt
and lock washer, supplied in loose parts.
Important
Make sure that the seat switch wire is
connected to the seat switch connector on the harness.
3. Slide the seat completely forward and backward to
ensure proper operation and that seat switch wires and
connectors are not pinched or do no contact any moving
parts.
Qty.
Use
1
2
Installing the seat belt
2
1
Installing the manual tube
2
5
Apply to machine for CE compliance.
2
1
1
2
Read before operating the machine.
1
1
View before operating machine
1
Fill out and return to Toro
Greasing the Machine
Before the machine is operated, it must be greased to
ensure proper lubricating characteristics; refer to Greasing
the Bearings and Bushings. Failure to properly grease the
machine will result in premature failure of critical parts.
14
Advertisement
Table of Contents
