Toro 74946 Operator's Manual page 38

5. Gently slide the primary filter out of the air-cleaner
body (Figure 45).
Note: Avoid knocking the filter into the side of the
body.
6. Remove the safety filter only if you intend to replace it.
Important: Do not attempt to clean the safety
filter. If the safety filter is dirty, then the primary
filter is damaged. Replace both filters.
7. Inspect the primary filter for damage by looking into
the filter while shining a bright light on the outside of
the filter.
Note: Holes in the filter appear as bright spots. If the
filter is damaged, discard it.
Servicing the Primary Filter
•
If the primary filter is dirty, bent, or damaged, replace it.
•
Do not clean the primary filter.
Servicing the Inner Filter
Replace the inner filter, never clean it.
Important: Never attempt to clean the safety filter.
If the safety filter is dirty, then the primary filter is
damaged. Replace both filters.
Installing the Filters
Important: To prevent engine damage, always operate
the engine with both air filters and cover installed.
1. If installing new filters, check each filter for shipping
damage.
Note: Do not use a damaged filter.
2. If you are replacing the inner filter, carefully slide it into
the filter body (Figure
3. Carefully slide the primary filter over the inner filter
(Figure 45).
Note: Ensure that the primary filter is fully seated by
pushing on its outer rim while installing it.
Important: Do not press on the soft inside area
of the filter.
4. Position the air-cleaner cover, so that the breather valve
does not interfere with the throttle mechanism
46).
45).
(Figure
1
2
1. Air-cleaner cover
2. Throttle mechanism
5. Secure the cover with the latches
38
G016165
Figure 46
3. Breathe valve
(Figure 46).
3