Mounting The Expansion Interface Card; Mounting The 408E-A1/008E-A1/000E-A1/1Priu-C1 Pcbs; Figure 2-63 Removing The Sub-Cover - NEC SL1000 Hardware Manual

ISSUE 3.0
Items
IP4WW-2BRIDB-C1
IP4WW-1PRIU-C1

3.3 Mounting the Expansion Interface Card

DO NOT POWER ON until all installation has been completed.
Fit the optional 2BRIDB-C1 daughter boards before installing the 000E-A1/008E-A1 PCBs. Set the
switches on the 2BRIDB-C1 board before mounting it onto the 000E-A1/008E-A1 PCB.

3.3.1 Mounting the 408E-A1/008E-A1/000E-A1/1PRIU-C1 PCBs

The procedure for mounting the expansion interface cards is as follows;
• Do Not Power on until all installation have been completed.
• If Expansion KSU(s) are installed, turn the power on/off in the order of
Expansion 3 KSU, Expansion 2 KSU, Expansion 1 KSU and then Main
KSU.
1. Turn off the system power and disconnect the AC cord from KSU.
2. Open and remove the Sub-cover.
Hardware Manual
List of Contents
2BRIDB-C1 PCB
Nylon Spacers
2BRI Label
Metal Spacers
Screws (with circular washer)
1PRIU-C1 PCB (with PKG Spacer)
Nylon Spacers
Metal Spacers
Screws (with circular washer)
Sub-Cover

Figure 2-63 Removing the Sub-cover

Sub-Cover
Tab
SL1000
QTY
1
2
1
1
2
1
2
2
2
Tab
2-43