Safety And Instructional Decals - Toro 38535 Operator's Manual

•
If a shield, safety device, or decal is damaged, illegible,
or lost, repair or replace it before beginning operation.
Also, tighten any loose fasteners.
•
Do not smoke while handling gasoline.
•
Do not use the snowthrower on a roof.
•
Do not touch the engine while it is running or soon
after it has stopped because the engine may be hot
enough to cause a burn.
•
Perform only those maintenance instructions described
in this manual. Before performing any maintenance,
service, or adjustment, stop the engine, remove the key,
and disconnect the wire from the spark plug. If major
repairs are ever needed, contact an Authorized Service
Dealer.
•
Do not change the governor settings on the engine.
•
When storing the snowthrower for more than 30 days,
drain the fuel from the fuel tank to prevent a potential
hazard. Store fuel in an approved fuel container.

Safety and Instructional Decals

Important: Safety and instruction decals are located near areas of potential danger. Replace damaged decals.
60-9480
94-2561
1. Hot surface/burn hazard—keep bystanders a safe distance from
the machine.
94-2577
1. To engage the auger, hold the control bar against the handle.
2. To disengage the auger, release the control bar.
Remove the key from the ignition switch before storing
the snowthrower.
•
Purchase only genuine Toro replacement parts and
accessories.
Sound Pressure
This unit has a maximum sound pressure level at the
operator's ear of 91 dBA, based on measurements of
identical machines per EN 11201.
Sound Power
This unit has a guaranteed sound power level of 108 dBA,
based on measurements of identical machines per EN 3744.
Vibration
This unit does not exceed a hand/arm vibration level of
15.5 m/s 2 , based on measurements of identical machines
per EN 1033.
1. Cutting/dismemberment hazard, impeller and auger—stay
away from moving parts; remove the ignition key and read the
instructions before servicing or performing maintenance.
3
94-2901