Table Of Contents - Toro 38535 Operator's Manual

Figure 5
3. Loosely install the handle bolts, curved washers, and
knobs (Figure 6).
Figure 6
4. Hook the end of the control cable spring into the
bottom hole of the control bar (Figure 7).
Figure 7
5. Fully insert the handle bolts (Figure 8).
Important: Ensure that you do not pinch the
control cable (Figure 8).
Figure 8
6. Tighten the knobs until they are snug.
7. Adjust the control cable. Refer to Adjusting the Control
Cable.
3. Installing the Discharge
Chute
Install the discharge chute as shown (Figure 9).
Figure 9
6