Toro 02740 Operator's Manual page 48

1.48
Daily And Before Use continued
Clean the primary radiator screen:
Clean the primary radiator screen. Check the oil
cooler, secondary screen and engine radiator grille
for debris and clean as necessary using a brush or
airline. The secondary screen can be removed for
cleaning. Re-assemble the secondary screen. If
water is used, these areas should be allowed to dry
out completely before use.
IMPORTANT: PREVENT DAMAGE -
NEVER operate the mower with a damaged
radiator screen or engine damage could result
from overheating. Clean the radiator screen
more regularly in dry conditions.
Check fuel level: Top up as necessary with diesel
fuel. Always top up before storing the mower over-
night to prevent water condensation from contami-
nating the fuel.
Check hydraulic oil level: If the oil level is below
the upper mark on the sight level gauge, top up
with the correct grade of hydraulic oil as necessary,
refer to SPECIFICATIONS.
WARNING: PREVENT DAMAGE - If there
is noticeable hydraulic oil loss, the leakage
source must be rectified before using the mower.
NEVER operate the mower when the hydraulic
oil level is below the bottom mark on the sight
level gauge. NEVER operate the mower with
contaminated oil.
Check hydraulic hose-lines: Inspect hydraulic
hose-lines for signs of wear or damage.
WARNING: PREVENT ACCIDENTS -
ALWAYS replace worn or damaged hydraulic
hose-lines immediately. DO NOT operate the
mower with defective hydraulic hose-lines.
Inspect the mower for signs of oil leakage. Tighten
fittings or replace seals as required.
MAINTENANCE
1
1. Radiator primary screen
2. Oil cooler
3. Secondary screen
D
2
1
1. Sight level gauge
2. Oil tank
3. Oil filler cap
4. Fuel tank
1.48
3
2
4
3