Mk3 200Mm Floating Cutterhead - Toro 02740 Operator's Manual

1.43 OPERATING THE MOWER 1.43
MK3 200 mm (8˝) Floating Cutterhead
Pivot knuckle fixing: Secure the bolt in the rear
A
'floating' slot position 'A' as shown.
Height of cut adjustment: The height of cut is
B
gauged by the position of the front and rear rollers.
To alter the rear roller position, turn the adjusting
nut assembly 'B' both ends clockwise to decrease
D
height of cut 'E' or anti-clockwise to increase
A
height of cut 'E'.
E
IMPORTANT: PREVENT DAMAGE - Do not
attempt to unlock the nut assemblies, 'B'.
To alter the front roller position loosen bolts 'F'.
Release and turn adjusting nuts 'D' both ends
clockwise to increase the height of cut or anti-
clockwise to decrease the height of cut.
C
Ensure that all cutterheads are set at the same
E
=
height of cut by referring to the indicator rings 'C'
or use the height of cut gauge across the full width
of each cutterhead as shown.
Tighten nuts 'D' and 'F' both ends.