Setup; Loose Parts Chart; Tractor Requirements; Ballast Requirements - Toro 09701 Operator's Manual

Setup

Note: Determine the left and right sides of the machine from the normal operating position.

Loose Parts Chart

Note: Use this chart as a checklist to ensure all parts necessary for assembly have been shipped. If any of these parts are
missing, total setup cannot be completed.
Description
PTO drive shaft
Rear castor/safety shield
Side guards
Keys
Operator's Manual
Parts Catalog

Tractor Requirements

• 24 horsepower—660
• 32 horsepower—880
• Correct tire pressure
• Category one 3 point hitch, rated to lift at least a
1400 lb. (637 Kg) implement–660
• Category one 3 point hitch, rated to lift at least a
1700 lb. (771 Kg) implement–880
• 540 rpm tractor PTO
• Adequate front-end weight (ballast)

Ballast Requirements

Caution
To help prevent bodily injury and provide added
stability, make sure front of the tractor is
equipped with proper ballast. Refer to tractor
operator's manual for ballast requirements.
• Refer to Tractor Operator's Manual for ballast
requirements.
Qty. Use
1 Transfers power from tractor to aerator
1 Support aerator for maintenance/storage
2 Keeps hands and feet away from tines
2 For hood latch on TE models
2 Read before operating machine
1 Service part identification

Connect Lower Link Arms

1. Aerator must be positioned on a flat, level surface for
installation.
2. Back tractor squarely up to aerator until lower link
arms are aligned with hitch pins.
3. Make sure PTO is disengaged.
4. Engage parking brake, STOP engine and remove key
from ignition. Wait for engine and all moving parts to
STOP before leaving operator's seat on tractor.
5. Insert right and left lower link arms onto hitch pins
(Fig. 2).
1
1. Lower link
6. Secure lower link arms to hitch pins with lynch pins
(Fig. 2).
9
2
Figure 2
2. Lynch pin