Servicing Castor Wheel And Bearing - Toro 30743 Operator's Manual

Servicing Castor Wheel And
Bearing
The castor wheel rotates on a high–quality sealed roller
bearing and is supported by a spanner bushing. Even after
many hours of use the bearing wear will be minimal. A
wobbly castor wheel usually indicates a worn bearing.
1. Remove locknut from capscrew holding castor wheel
assembly in castor fork. Grasp castor wheel and slide
capscrew out of fork.
2. Remove outer bearing from wheel hub and allow
bearing spacer to fall out. Remove outer bearing from
opposite side of wheel hub.
1
2
Figure 8
1. Bearing
3. Check the bearings, spacer and inside of wheel hub for
wear. Replace defective parts as required.
4. To assemble the castor wheel, push outer bearing into
wheel hub. Slide bearing spacer into wheel hub. Push
other bearing into open end of wheel hub to captivate
the spacer inside the wheel hub.
5. Install castor wheel assembly in castor fork and secure
in place with capscrew and locknut.
1
2. Spacer
14