Fuel System Maintenance; Inspecting Fuel Lines And Connections; Replacing The Fuel Filter; Electrical System Maintenance - Toro 07277 Operator's Manual

Fuel System
Maintenance
Inspecting Fuel Lines and
Connections
Check the fuel lines and connections every 400 operating
hours or yearly, whichever occurs first. Inspect them for
deterioration, damage, or loose connections.

Replacing the Fuel Filter

Replace the fuel filter every 800 operating hours or
yearly, whichever occurs first.
1. Raise the box and support it with the prop rod.
2. Place a clean container under the fuel filter.
3. Remove the clamps securing the fuel filter to the fuel
lines (Figure 37).
Figure 37
1. Fuel filter
4. Install the replacement filter to the fuel lines with the
clamps previously removed.
Mount the filter so that the arrow points toward the
carburetor.
Electrical System
Maintenance

Replacing the Fuses

There are 3 fuses in the electrical system. They are
located beneath the bed in a box on the right hand side
of the frame (Figure 38).
Ignition System
Lights
Power Point
1. Ignition system
2. Lights

Replacing the Headlights

Specification: GE Headlight #H7610
1. Set the parking brake, turn the ignition off, and
remove the key.
2. Reach beneath the dash and push the headlight out
of the hood.
3. Remove the screws attaching the wire harness to
the headlight.
4. Remove the rubber seal from around the headlight
(Figure 39). Discard the headlight.
31
10 amp. (15 amp. max.)
Figure 38
3. Power point
10 amp.
10 amp.