Installing The Steering Wheel; Installing The Bumper; Installing The Seats - Toro 07277 Operator's Manual

1. Wheel assembly
2. Wheel nut
2

Installing the Steering Wheel

Parts needed for this procedure:
1 Steering wheel
Procedure
Note: This procedure is only needed for Model No.
07277TC.
1. Remove the nut and washer from the steering shaft.
2. Slide the steering wheel and washer onto the shaft.
Position the steering wheel on the shaft so that the
cross beam is horizontal when the tires are pointed
straight ahead and the thicker spoke of the steering
wheel is downward.
3. Secure the steering wheel to the shaft with the nut
(Figure 4). Torque the nut to 18-22 ft-lb (24-29 N-m)
1. Steering wheel
2. Nut
Figure 3
3. Wheel stud (rear wheel
hub shown)
Figure 4
3. Washer
4. Foam seal
3

Installing the Bumper

Parts needed for this procedure:
1 Bumper
Procedure
Note: This procedure is only needed for Model No.
07277TC.
1. Remove the 2 bolts, washers, and nuts secured to the
front of the frame.
2. Align the mounting holes and secure the bumper
to the frame with the fasteners previously removed
(Figure 5).
1. Bumper
4

Installing the Seats

Parts needed for this procedure:
2 Seat
Procedure
Note: This procedure is only needed for Model
No. 07277TC.
Insert the seat bracket into the seat base opening and
pivot the seat downward (Figure 6).
11
Figure 5