Toro 38182 Operator's Manual
Hide thumbs Also See for 38182:

Advertisement

CCR Powerlite 325
Snowthrower
Model No. 38182—Serial No. 230000001 and Up
Introduction
Read this manual carefully to learn how to operate
and maintain your product properly and to avoid injury
and product damage. You are responsible for
operating the product properly and safely.
Whenever you need service, genuine Toro parts, or
additional information, contact an Authorized Service
Dealer or Toro Customer Service and have the model
and serial numbers of your product ready. The
illustration below identifies the location of the model
and serial numbers on the product. Write the numbers
in the space provided below:
Model #:
Serial #:
This manual identifies potential hazards and has
safety messages identified by the following words:
Danger signals an extreme hazard that will
cause serious injury or death if you do not follow
the recommended precautions.
Warning signals a hazard that may cause
serious injury or death if you do not follow the
recommended precautions.
Caution signals a hazard that may cause minor
or moderate injury if you do not follow the
recommended precautions.
This manual uses 2 other words to highlight
information. Important calls attention to special
mechanical information and Note: emphasizes
general information worthy of special attention.
Warning
The engine exhaust from this product contains
chemicals known to the State of California to
cause cancer, birth defects, or other reproductive
harm.
Important: This engine is not equipped with a spark
arrester muffler. It is a violation of California Public
Resource Code Section 4442 to use or operate this
engine on any forest-covered, brush-covered, or
grass-covered land. Other states or federal areas
may have similar laws.
Printed in USA
Original Instructions (EN)
This spark ignition system complies with Canadian
ICES-002.
Safety
Read and understand the contents of this manual
before the engine is ever started.
This is the safety alert symbol. It is used to
alert you to potential personal injury hazards.
Obey all safety messages that follow this symbol
to avoid possible injury or death.
Improperly using or maintaining this
snowthrower could result in injury or death. To
reduce this potential, comply with the following
safety instructions.
The following instructions have been adapted from
the ANSI/OPEI standard B71.3–1995 and the ISO
2121
8437:1989 standard.
Training
Read the operator's manual carefully. Be
thoroughly familiar with the controls and the
proper use of the equipment. Know how to stop
the unit and disengage the controls quickly.
Never allow children to operate the snowthrower.
Never allow adults to operate the snowthrower
without proper instruction.
Keep the area of operation clear of all persons
(particularly small children) and pets.
Exercise caution to avoid slipping or falling.
Preparation
Thoroughly inspect the area where you will use
the snowthrower. Remove all doormats, sleds,
boards, wires, and other foreign objects.
Release the control bar to disengage the rotor
blades before starting the engine.
Do not operate the snowthrower without wearing
adequate winter garments. Wear footwear that
will improve your footing on slippery surfaces.
Handle fuel with care; it is highly flammable.
– Use an approved fuel container.
– Never add fuel to a running or hot engine.
3327-892
Form No. 3327-892
Operator's Manual
2002 by The Toro Company
All Rights Reserved

Advertisement

Table of Contents
loading

Summary of Contents for Toro 38182

  • Page 1 Whenever you need service, genuine Toro parts, or before the engine is ever started. additional information, contact an Authorized Service Dealer or Toro Customer Service and have the model This is the safety alert symbol. It is used to and serial numbers of your product ready. The alert you to potential personal injury hazards.
  • Page 2: Maintenance And Storage

    The following list contains safety information specific to Toro products or other safety information that you If the unit should start to vibrate abnormally, stop must know. the engine and check immediately for the cause.
  • Page 3: Safety/Instruction Decals

    Do not touch the engine while it is running or switch before storing the snowthrower. soon after it has stopped because the engine Purchase only genuine Toro replacement parts may be hot enough to cause a burn. and accessories. Perform only those maintenance instructions described in this manual.
  • Page 4: Product Overview

    Product Overview Setup Installing the Handle 1. Position the ends of the upper handle on the inside of the lower handle and align the holes. 2. Insert the oval-head bolts into the aligned holes, with the bolt heads on the outside of the handle.
  • Page 5: Before Starting

    Mixing Gasoline and Oil This snowthrower uses a 50:1 gasoline-to-oil mixture. Use Toro 50:1 2-Cycle Oil (Fuel Stabilizer Added) or an equivalent high-grade, NMMA TCW-certified two-cycle oil. Important: To prevent engine damage, do not use automotive oil (such as SAE 30 or 10W30) or fuel mixed at the wrong gasoline-to-oil ratio.
  • Page 6: Operation

    Adjusting the Discharge Operation Chute Note: Determine the left and right sides of the machine from the normal operating position. To adjust the discharge chute, move the chute handle (A) and the chute deflector handle (B) as shown. Starting the Engine 1.
  • Page 7: Preventing Freeze-Up After Use

    Preventing Freeze-up after Use With the engine off, pull the recoil starter handle several times to prevent the recoil starter from Let the engine run for a few minutes to prevent freezing up. moving parts from freezing. Stop the engine, wait for all moving parts to stop, and remove ice and snow from the snowthrower.
  • Page 8: Folding The Handle

    1. Add a fuel stabilizer/conditioner to the fuel in the fuel tank as directed. Note: If you use Toro 50:1 2-Cycle Oil (Fuel Stabilizer Added), you do not need to add a fuel stabilizer/conditioner. 2. Run the engine for 5 minutes to distribute the conditioned fuel through the fuel system.
  • Page 9 3327-892...
  • Page 10 3327-892...
  • Page 11 3327-892...
  • Page 12 If for any reason you are dissatisfied with your Distributor’s service or have difficulty obtaining guarantee information, contact the Toro importer. If all other remedies fail, you may contact us at Toro Warranty Company.

This manual is also suitable for:

Ccr powerlite 325

Table of Contents