Toro CCR Powerlite 38172 Operator's Manual

Snowthrower
Hide thumbs Also See for CCR Powerlite 38172:

Advertisement

Quick Links

CCR Powerlite
Model No. 38172—Serial No. 290000001 and Up
Model No. 38182—Serial No. 290000001 and Up
Introduction
Read this information carefully to learn how to operate
and maintain your product properly and to avoid injury
and product damage. You are responsible for operating
the product properly and safely.
You may contact Toro directly at www.Toro.com for
product and accessory information, help finding a
dealer, or to register your product.
Whenever you need service, genuine Toro parts, or
additional information, contact an Authorized Service
Dealer or Toro Customer Service and have the model
and serial numbers of your product ready. Figure 1
identifies the location of the model and serial numbers
on the product. Write the numbers in the space
provided.
Figure 1
1. Model and serial number location
Model No.
Serial No.
This manual identifies potential hazards and has
safety messages identified by the safety alert symbol
(Figure 2), which signals a hazard that may cause serious
injury or death if you do not follow the recommended
precautions.
Figure 2
1. Safety alert symbol
© 2008—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
Snowthrower
This manual uses 2 words to highlight information.
Important calls attention to special mechanical
information and Note emphasizes general information
worthy of special attention.
The engine exhaust from this product
contains chemicals known to the State of
California to cause cancer, birth defects,
Important: This engine is not equipped with a
spark arrester muffler. It is a violation of California
Public Resource Code Section 4442 to use or operate
this engine on any forest-covered, brush-covered, or
grass-covered land. Other states or federal areas
may have similar laws.
This spark ignition system complies with Canadian
ICES-002.
The enclosed Engine Owner's Manual is supplied
for information regarding the US Environmental
Protection Agency (EPA) and the California
Emission Control Regulation of emission systems,
maintenance, and warranty. Replacements may be
ordered through the engine manufacturer.
Safety
Read and understand the contents of this manual before
you start the engine.
This is the safety alert symbol. It is used to alert you
to potential personal injury hazards. Obey all safety
messages that follow this symbol to avoid possible injury
or death.
This snowthrower is capable of amputating hands and
feet and of throwing objects. Failure to observe the
following safety instructions could result in serious
injury.
Register at www.Toro.com.
Form No. 3360-734 Rev A
Operator's Manual
Warning
CALIFORNIA
Proposition 65 Warning
or other reproductive harm.
Original Instructions (EN)
Printed in the USA
All Rights Reserved

Advertisement

Table of Contents
loading

Summary of Contents for Toro CCR Powerlite 38172

  • Page 1 State of additional information, contact an Authorized Service California to cause cancer, birth defects, Dealer or Toro Customer Service and have the model or other reproductive harm. and serial numbers of your product ready. Figure 1...
  • Page 2 Training • Never attempt to make any adjustments while the engine is running (except when specifically • Read, understand, and follow all instructions on the recommended by manufacturer). machine and in the manual(s) before operating this • Always wear safety glasses or eye shields during unit.
  • Page 3: Clearing A Clogged Discharge Chute

    Toro Snowthrower Safety The following list contains safety information specific to Toro products or other safety information that you must know. • Rotating rotor blades can injure fingers or hands. Stay behind the handles and away from the discharge opening while operating the snowthrower.
  • Page 4: Safety And Instructional Decals

    Safety and Instructional Decals Important: Safety and instruction decals are located near areas of potential danger. Replace damaged decals. 104-2767 112-6647 (model 38182 only) Reorder part no. 112-8101 112-6648 (model 38172 only) Reorder Part No. 112-8100...
  • Page 5: Installing The Handle

    Belt Routing Diagram 114-9286 Setup Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. Oval-head bolts Curved washers Install the handle. Handle knobs Discharge chute Washers Install the discharge chute. Locknuts Knob 1.
  • Page 6: Installing The Discharge Chute

    2. Installing the Discharge Product Overview Chute Discharge chute Washers Locknuts Knob Procedure 1. Position the holes in the sides of the discharge chute over the bolts ends on the sides of the chute handle. (Figure 4). Figure 5 1. Discharge chute 4.
  • Page 7: Operation

    Mixing the Gasoline and Oil This snowthrower uses a 50:1 gasoline-to-oil mixture. Use Toro 50:1 2-Cycle Oil (Fuel Stabilizer Added) or an equivalent high-grade, NMMA TCW III-certified two-cycle oil. Important: To prevent engine damage, do not use automotive oil (such as SAE 30 or 10W30) or fuel mixed at the wrong gasoline-to-oil ratio.
  • Page 8: Stopping The Engine

    Preventing Freeze-up after Using the electric starter (model 38182 only): A. Connect the power cord to the snowthrower and to a standard household power outlet and push • Let the engine run for a few minutes to prevent the starter button. moving parts from freezing.
  • Page 9: Recommended Maintenance Schedule(S)

    Maintenance Note: Determine the left and right sides of the machine from the normal operating position. Recommended Maintenance Schedule(s) Maintenance Service Maintenance Procedure Interval • Check for loose fasteners and tighten them if necessary. After the first hour • Have an Authorized Service Dealer replace the rotor blades and the scraper if necessary.
  • Page 10: Storing The Snowthrower

    1. Add a fuel stabilizer/conditioner to the fuel in the Figure 12 fuel tank as directed. Note: If you use Toro 50:1 2-Cycle Oil (Fuel 3. Loosen the knobs on the handle and fold the handle Stabilizer Added), you do not need to add a fuel down over the snowthrower.
  • Page 11 Notes:...
  • Page 12 Instructions for Obtaining Warranty Service If you think that your Toro Product contains a defect in materials or workmanship, or if a normal, able-bodied adult can no longer start your product’s engine in one or two pulls, follow this procedure: 1.

This manual is also suitable for:

Ccr powerlite 38182

Table of Contents