Toro 22337CP Operator's Manual page 6

• Use extra care when handling fuels. They are
flammable and vapors are explosive.
– Use only an approved container.
– Never remove the fuel cap or add fuel when
the engine is running. Allow the engine to cool
before refueling. Do not smoke.
– Never refuel the traction unit indoors.
– Never store the traction unit or fuel container
inside where there is an open flame, such as near
a water heater or furnace.
– Never fill a container while it is inside a vehicle,
trunk, pickup bed, or any surface other than the
ground.
– Keep container nozzle in contact with the tank
during filling.
• Stop and inspect the equipment if you strike an
object. Make any necessary repairs before restarting.
• Use only genuine Toro replacement parts to ensure
that original standards are maintained.
• Battery acid is poisonous and can cause burns. Avoid
contact with skin, eyes, and clothing. Protect your
face, eyes, and clothing when working with a battery.
• Battery gases can explode. Keep cigarettes, sparks
and flames away from the battery.
• Keep your body and hands away from pin hole
leaks or nozzles that eject high pressure hydraulic
fluid. Use cardboard or paper to find hydraulic
leaks; never use your hands. Hydraulic fluid escaping
under pressure can penetrate skin and cause injury
requiring surgery within a few hours by a qualified
surgeon or gangrene may result.
Sound Pressure Level
This unit has a sound pressure level at the operator's
ear of 90 dBA, which includes an Uncertainty Value (K)
of 1 dBA.
Sound pressure level was determined according to the
procedures outlined in EN 11201.
Sound Power
This unit has a guaranteed sound power level of 101
dBA, which includes an Uncertainty Value (K) of 1 dBA.
The sound power level was determined according to the
procedures outlined in ISO 6395.
Vibration Level
Measured vibration level for right hand = 0.1 m/s
Measured vibration level for left hand = 0.1 m/s
Uncertainty Value (K) = 0.1 m/s
Measured values were determined according to the
procedures outlined in EN ISO 20643.
2 .
6
2 .
2
.