Toro 22302TE Operator's Manual page 23

the traction unit. The warranty of the traction
unit may be voided if used with unapproved
attachments.
IMPORTANT: Before installing the
attachment, ensure that the mount plates are
free of any dirt or debris.
1. Position the attachment on a level surface with
enough space behind it to accommodate the
traction unit.
2. Move the pump selector lever to the slow (turtle)
position.
3. Start the engine.
4. Slowly push the attachment tilt lever forward to
tilt the attachment mount plate forward.
5. Position mount plate into the upper lip of the
attachment receiver plate (Fig. 15).
2
Figure 15
1. Mount plate
6. Raise the loader arms while tilting back the
mount plate at the same time.
IMPORTANT: The attachment should be
raised enough to clear the ground and the
mount plate tilted all the way back.
7. Stop the engine.
8. Engage the quick attach pins (Fig. 16).
1
m–4055
2. Receiver plate
1
Figure 16
1. Quick attach pins (shown in engaged position)
Connecting the Hydraulic Hoses
If the attachment requires hydraulics for operation,
connect the hydraulic hoses as follows:
1. Stop the engine.
2. Move the auxiliary hydraulics lever forward,
backward, and back to neutral to relieve pressure
at the hydraulic couplers.
IMPORTANT: Ensure that all foreign matter
is cleaned from the hydraulic connections.
3. Remove the protective covers from the hydraulic
couplers on the traction unit. Connect the covers
together to prevent contamination during
operation.
4. Slide the collar back on the hydraulic couplers
and connect the attachment couplers to the
traction unit couplers.
Operation
m–4056
21