Loose Parts; Unfolding The Handle - Toro Snow Commander 38600 Operator's Manual

Setup

Loose Parts

Use the chart below to verify that all parts have been shipped.
Step
1.
2.

1. Unfolding the Handle

1. Cut the plastic tie that secures the control cable to the
handle.
2. Loosen the knobs and pull out the handle bolts (Figure
3).
Figure 3
3. Rotate the upper handle to the operating position
(Figure 4).
Reorder Part No. 104-0874
Description
No parts required
Discharge chute
Phillips head screws
Washers
Locknuts
105-1978
Qty.
–
Unfold the handle.
1
3
Install the discharge chute.
3
3
Figure 4
4. Install the handle bolts, set the cable guide in position,
and tighten the knobs until they are snug (Figure 5).
5
Use