Toro 72071 Setup Instructions
Toro 72071 Setup Instructions

Toro 72071 Setup Instructions

Lawn & garden tractor

Advertisement

Quick Links

Loose Parts

Note:
Use the chart below to identify parts for assembly.
DESCRIPTION
Front Wheel
Flat Washer-large OD
Shim Washer
Dust Cover
Cotter Pin
Rear Wheel
Wheel Bolt
Steering Wheel
Lock Washer 1/2"
Nut 1/2"
Logo Cover
Seat
Spacer-small ID
Spacer-large ID
Shoulder Bolt
Knob
Flat Washer
Bolt 1/4–20 x 3/4"
Wing Nut-plastic 1/4"
Key
Operator's Manual
Printed in USA
LAWN & GARDEN TRACTOR
MODEL NO. 72071–200000001 & UP
MODEL NO. 72107–200000001 & UP
MODEL NO. 72116–200000001 & UP
QTY.
2
2
4
2
2
2
10
1
1
1
1
1
2
2
2
2
2
2
2
1
1
The Toro Company – 1999
All Rights Reserved
INSTRUCTIONS
USE
Install front wheels.
Install rear wheels.
Install steering wheel.
Install the seat.
Attach battery cables.
Use in ignition and "Key Choke" switches.
Read manual before operating tractor.
FORM NO. 3322-970
SET UP

Advertisement

Table of Contents
loading

Summary of Contents for Toro 72071

  • Page 1: Loose Parts

    FORM NO. 3322-970 LAWN & GARDEN TRACTOR MODEL NO. 72071–200000001 & UP SET UP MODEL NO. 72107–200000001 & UP MODEL NO. 72116–200000001 & UP INSTRUCTIONS Loose Parts Note: Use the chart below to identify parts for assembly. DESCRIPTION QTY. Front Wheel Flat Washer-large OD Install front wheels.
  • Page 2: Install Front Wheels

    Set Up Instructions Install Front Wheels Install Rear Wheels Note: If wheels are already installed, refer to Install wheel onto axle with valve stem to the Check Tire Pressure (below). inside (Fig. 2). Torque wheel bolts to 75-80 ft-lb (105-112 N . m). Slide wheel onto axle with valve stem in.
  • Page 3: Install Steering Wheel

    Set Up instructions Install Steering Wheel Install Seat Position front wheels straight ahead. Note: If the seat is already installed, proceed to Activate The Battery, page 4. Remove logo cover by releasing (3) latches from back side with screwdriver. Install large ID spacer and shoulder bolts into rear holes of seat (Fig.
  • Page 4: Activate The Battery

    Set Up Instructions Activate the Battery Bulk electrolyte with 1.260 specific gravity must be purchased from a local battery supply outlet. Remove the battery from the tractor: refer to Operator’s Manual, Removing the Battery. IMPORTANT: Be careful not to damage the long vent tube when removing the battery box.
  • Page 5: Test Drive The Tractor

    Set Up instructions Check Safety System Refer to the Operator’s Manual, Checking Safety POTENTIAL HAZARD System. Charging battery produces gasses. WHAT CAN HAPPEN Test Drive the Tractor Battery gasses can explode. HOW TO AVOID THE HAZARD Make sure all electrical and mechanical systems are Keep cigarettes, sparks and flames away operating properly.
  • Page 6 Set Up Instructions...
  • Page 7 Set Up instructions...
  • Page 8 Set Up Instructions...

Table of Contents