Specifications; General Specifications; Optional Equipment - Toro 30722 Groundsmaster 300 Operator's Manual

Specifications

General Specifications

Width of Cut
Height-of-Cut
Cutter Housing
Cutting Unit Drive
Cutting Unit
Castor Wheels
Blade Tip Speed
Cutting Unit Lift
Width
Weight

Optional Equipment

High Sail Blade
23 x 10.5 x 12 Tire and Wheel
(Model 30722 only)
Blade and Belt Kit
Blade and Belt Kit (Hi-Lift)
Front Castor Wheel
Rear Castor Wheel
Left-Hand Spindle Assembly
Center Spindle Assembly
Right-Hand Spindle Assembly
Leaf Mulcher Kit
Quick Attach Kit
Atomic Blade
Front Castor Wheel (Foam Filled)
Models 30722 and 30710 have a 71-1/2 inch (1.816 m) width of cut.
Adjustable from 1 to 4 in. (25 to 102 mm) in 1/2 in. (13 mm) increments
Both cutter housings are made from 11 gauge (13 mm) steel and reinforced with
3-1/2 inch (89 mm) x 7 gauge (4.76 mm) channel iron.
Gear box mounted on cutting unit is driven by PTO shaft. Power is transmitted to
the blades by three B section belts. Spindle shafts are 1-1/4 inch (32 mm) in
diameter and supported by two externally sealed, greaseable, tapered roller
bearings.
Front mounted cutting units have front and rear caster wheels, three heat-treated
steel blades 25 inches (0.63 m) long and 1/4 inch (6 mm) thick.
Two front castor wheels have roller bearings with 10.25 in. (260 mm) x 3.25 in.
(83 mm) hard rubber tires. Rear wheels have roller bearings and 6 in. (153 mm) x
2.50 in. (64 mm) hard rubber tires.
At 3200 engine rpm, blade tip speed is 15,000 ft/min. (76.2 m/sec.).
Cutting units are lifted by hydraulic cylinder that has a 2-1/2 in. (64 mm) bore and
3-1/4 in. (82 mm) stroke.
Model 30722 & 30722TE: 85-1/2 in. (2.17 m)
Model 30710 & 30710TE: 76 in. (1.93 m)
Model 30722 & 30722TE: 400 lb. (181.4 kg)
Model 30710 & 30710TE: 415 lb. (188.2 kg)
Part No. 23-2410
Part No. 36-1050
Part No. 95-3087
Part No. 95-3094
Part No. 95-3082
Part No. 95-3084
Part No. 95-3089
Part No. 95-3090
Part No. 95-3095
Model No. 30733
Model No. 30719
Part No. 106–4354
Part No. 93–5973
7