Canon VB-C500VD Start Manual page 51

Use of External Power Supply
An AC adapter, or 12-VDC or 24-VAC input can be used for the external power supply.
Connect the bundled power interface cable (WP500-VB) as shown below.
Power interface cable
(Non-polar)
Use a 12-VDC or 24-VAC power supply insulated from 100 VAC.·
12 VDC can be connected in a non-polar condition.
Use the power supply within the following voltage range.
24 VAC: Voltage fluctuation within 24 VAC±10%
(50 or 60 Hz within ± 0.5 Hz)
Current supply capacity per camera 0.23 A
12 VDC: Voltage fluctuation within 12 VDC±10%
Current supply capacity per camera 0.36 A
* If a 12-VDC battery power supply is used, be sure to connect a resistor of 0.5 to 1.0Ω/20 W
or more to the power line.
* Use double-insulated devices for the external power supply.
Applicable wires and recommended power cable length
Applicable cable (AWG)
Conductor size (Φmm, Φinch)
Maximum cable length, 12 VDC (m (ft))
Maximum cable length, 24 VAC (m (ft))
Use a UL cable (UL-1015 or equivalent) for wiring 12 VDC or 24 VAC.
Step 2 Connect the Camera to the Network
Screwdriver
Tightening torque:
0.4N·m (3.54lbf·in) (max.)
Stripping length
Approx. 5 mm
(0.20 in)
AC adapter
#18
(single wire Φ1.0 mm
(Φ0.039 in), stranded wire
Φ1.2 mm (Φ0.047 in))
23 (75.5)
46 (150.9)
This completes the network connection.
#16
(single wire Φ1.3mm
(Φ0.051 in), stranded wire
Φ1.6mm (Φ0.063 in))
32 (105.0)
64 (210.0)
2-9