Cub Cadet Time Saver Operator's Manual page 23

9. Peel the backing off of the self-adhesive foam strip (721-
04388) that has been included with your grass collector.
Apply it to the upper chute, flush against the flange as
shown in Fig. 6-13.
Flange
Figure 6-13
10. With the grass catcher cover open, install the discharge
chute over the chute extension tube, as seen in Fig. 6-14,
and rest the top end into the upper chute support installed
on the right-hand side of the bag support assembly. See
Fig. 6-15.
Note: The groove on the upper chute should be aligned
with the upper chute support, as seen in the inset of Fig.
6-15.
s 6 — b a
ectiOn agger sseMbly
Figure 6-14
Figure 6-15
& i : t u
nstallatiOn riple pper
b c 23
agger OMpOnents