Cub Cadet Time Saver Operator's Manual page 22

6. Slide the hinge pin into the hole located on the mounting
tab, as in Fig. 6-9. Use the cut-out window (See inset in Fig.
6-9) to line up the hinge pin on the other side and push pin
all the way in until it reaches the end-stop. At this point the
pin clips into place and is secured by a tab in the bagger
cover. See Fig. 6-10.
22 s 6 — b
ectiOn agger
Figure 6-9
Figure 6-10
a & i : t
sseMbly nstallatiOn riple
7. Open Hood by pushing in on the rear, right-side tab with
your right hand, as seen in 1 of Fig. 6-11, and lifting the cover
with your left hand in the center rear of the bagger cover, 2.
2
8. Install the grass bags onto the bag support assembly by
inserting the front edge in first (1), as seen in Fig. 6-12,
and setting the back edge down (2) until it fits into the
assembly.
u b c
pper agger OMpOnents
Figure 6-11
1
2
Figure 6-12
1