Driving The Tractor - Cub Cadet XT3 enduro series Operator's Manual

Reverse Caution Mode
The REVERSE CAUTION MODE
module allows the tractor to be operated in reverse with the
blades (PTO) engaged.
NOTE: Mowing in reverse is not recommended.
WARNING!
Use extreme caution while operating
the tractor in the REVERSE CAUTION MODE
Always look down and behind before and while
backing. Do not operate the tractor when children
or others are around. Stop the tractor immediately if
someone enters the area.
To use the REVERSE CAUTION MODE
NOTE: The operator MUST be seated in the tractor seat.
1. Start the engine as previously instructed on the previous
page.
2. Turn the key from the NORMAL MOWING
position to the REVERSE CAUTION MODE
position of the key switch module. See Figure 5-1.
Indicator
Light
Stop
Position
Figure 5-1
3. Press the REVERSE PUSH BUTTON
corner of the key switch module. The red indicator light
at the top, left corner of the key switch module will be ON
while activated. See Figure 5-1.
4. Once activated (indicator light ON), the tractor can be
driven in reverse with the cutting blades (PTO) engaged.
5. Always look down and behind before and while backing to
make sure no children are around. After resuming forward
motion, return key to the NORMAL MOWING
The REVERSE CAUTION MODE
a. The key is placed in either the NORMAL MOWING
position or STOP
b. The operator leaves the seat.
position of the key switch
.
:
(Green)
(Yellow)
Reverse
Push Button
Reverse
Caution Mode
Position
Start
Position
at the top, right
position.
will remain activated until:
position or

Driving The Tractor

WARNING!
Avoid sudden starts, excessive speed
and sudden stops.
1. Lightly press the brake pedal
. Move the throttle lever into the FAST
2. To travel FORWARD, slowly press the forward drive pedal
forward until the desired speed is achieved. See Figure 5-2.
Forward Drive Pedal
Figure 5-2
3. To travel in REVERSE, check that the area behind is clear then
slowly depress the reverse drive pedal
speed is achieved. See Figure 5-2.
CAUTION:
Do NOT attempt to change the
direction of travel when the tractor is in motion.
Always bring the tractor to a complete stop before
changing from forward to reverse or vice versa.
WARNING!
Do not leave the seat of the tractor
without first placing the PTO/Blade Engage lever in
the OFF position and engaging the parking brake. If
leaving the tractor unattended, also turn the engine
off and remove the ignition key.
to release the parking brake
position.
Reverse Drive Pedal
until the desired
S 5 — o
ection peration
15