Operation - Cub Cadet XT3 enduro series Operator's Manual

Operation

WARNING!
and down slopes, not across. Avoid sudden turns.
Do not operate unit where it could slip or tip. If
machine stops going uphill, stop PTO and back
down the hill safely. Keep safety devices (guards,
shields and switches) in place and working. Remove
objects that could be thrown by the blades. Know
location and function of all controls. Be sure the
blades and the engine are stopped before placing
hands or feet near blades. Before leaving operator's
position, disengage PTO, engage brake lock, shut off
and remove key.
Safety Interlock Switches
This tractor is equipped with a safety interlock system for the
protection of the operator. If the interlock system should ever
malfunction, do not operate tractor. Contact your Cub Cadet dealer.
• The safety interlock system prevents the engine from
cranking or starting unless the parking brake is engaged,
and the PTO (Blade Engage) knob is in the disengaged
(OFF) position.
• The engine will automatically shut off if the operator leaves
the seat before engaging the parking brake.
• The electric PTO (Blade Engage) clutch will automatically
shuts off if the operator leaves the tractor's seat with the
PTO (Blade Engage) knob in the engaged (ON) position,
regardless of whether the parking brake is engaged.
• With the ignition key in the NORMAL MOWING position,
the electric PTO (Blade Engage) clutch will automatically
shut off if the PTO (Blade Engage) knob is moved into the
engaged (ON) position with the drive pedal in position for
Reverse travel.
WARNING!
interlock system is malfunctioning. This system was
designed for your safety and protection.
Starting the Engine
WARNING!
interlock system is malfunctioning. This system was
designed for your safety and protection.
NOTE: Refer to the Assembly & Set-up section of this manual for
Gasoline and Oil fill-up instructions.
1. Insert the tractor key into the ignition switch module.
2. Place the PTO/Blade Engage lever to OFF position.
3. Engage the tractor's parking brake
4. Push the choke control upward into the choke on
position.
NOTE: If the engine is warmed up, it may not be necessary
to place the choke control in the choke position.
14
Avoid serious injury or death. Go up
Do not operate the tractor if the
Do not operate the tractor if the
.
5. Move the throttle control lever to midway between the
FAST and SLOW
NOTE: When operating the tractor be certain that the
throttle lever is always in the FAST
Operating with the throttle at less than full throttle may
lead to shortened battery life.
6. Turn the ignition key clockwise to the START
After the engine starts, release the key. It will return to the
NORMAL MOWING
CAUTION:
Do NOT hold the key in the START
position for longer than ten seconds at a time. Doing
so may cause damage to your engine's electric
starter.
6. After the engine starts, deactivate the choke control.
NOTE: Do NOT leave the choke control on while operating
the tractor. Doing so will result in a "rich" fuel mixture and
cause the engine to run poorly.
Stopping the Engine
WARNING!
If you strike a foreign object, stop the
engine and disconnect the spark plug wire(s).
Thoroughly inspect the machine for any damage.
Repair the damage before restarting and operating
1. If the blades are engaged, place the PTO/Blade Engage
lever in the OFF position.
2. Place the throttle control near the SLOW
3. Turn the ignition key counterclockwise to the STOP
position.
4. Remove the key from the ignition switch to prevent
unintended starting.
5
positions.
(rabbit) position.
position.
position.
position