Table of Contents
Advertisement
Replacing the filters
Slide the filter onto the inner shroud.
Removing and cleaning the brush bar
If the brush bar jams during use, the
AirRam will stop and the LEDs will appear
red. Before checking for a blockage,
remove the battery.
Slide the filter and inner shroud into the
filter housing.
Rest the AirRam on its side and locate the
brush bar button on the right hand side.
Press the button inwards and then pull
the brush bar towards the bottom of the
AirRam.
11
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the AirRam AR20 and is the answer not in the manual?
Questions and answers
Am unable to press button to release brush roller, it seems to be jammed
To fix a jammed brush roller release button on a Gtech AirRam AR20:
1. Turn off the device and remove the battery for safety.
2. Try to remove the brush bar by starting at the button end.
3. If the button is stuck, check for debris or hair around the release area that may be blocking movement.
4. Use scissors to cut and remove hair or debris from the groove along the brush bar.
5. Once clear, reinsert the brush bar by first inserting the end furthest from the button, then push the rest in until it clicks into place.
If the problem persists, follow the troubleshooting steps: empty the bin, check bin and filter fitment, clean or replace the filter, and check the brush bar fitment.
This answer is automatically generated