Starter/Reverse Motor Removal; Starter/Reverse Motor Disassembly/Inspection - Honda GL1800 Service Manual
Hide thumbs
Also See for GL1800:
- Owner's manual (251 pages) ,
- Setup instructions (32 pages) ,
- Quick start manual (5 pages)
Table of Contents
Advertisement
STARTER/REVERSE SYSTEM
STARTER/REVERSE MOTOR
REMOVAL
Remove the following:
– fuel tank (page 5-56).
– reverse shift arm (page 19-42)
Slide the rubber cap off the starter motor terminal
and remove the terminal nut and starter/reverse
motor cable.
Remove the three starter/reverse motor mounting
bolts.
-RING
STARTER/REVERSE M T R
Remove the starter/reverse motor from the rear
crankcase cover as shown and remove the O-ring
from the starter motor.
DISASSEMBLY/INSPECTION
Remove the three starter/reverse motor case bolts.
Remove the following:
GEAR CA E
EAL RING
– reduction gear case
– seal ring
– gear base washer
– gear base
– washer
GEAR BA E
19-17
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the GL1800 and is the answer not in the manual?
Questions and answers
how to remplace 35300-MCA-000 SWITCH SET,RR. STOP & CRUISE
Need manual for the Gold Wing 1800 Radio. All parts of radio itself works, except the intercom.
You can find a manual for the Honda Gold Wing 1800 radio, including intercom troubleshooting, by purchasing a shop manual. One user suggested ordering it from eBay. The shop manual provides details on maintenance, component locations, and troubleshooting procedures.
This answer is automatically generated
engine surges at idle
The Honda GL1800 engine may surge at idle due to improper synchronization between the Idle Air Control Valve (IAVC) and the throttle body. Other possible causes include incorrect idle screw settings, faulty oxygen sensors (O2 sensors), or an idle speed set too low (e.g., below 600 rpm). The surging may stop if the idle is adjusted to around 800 rpm.
This answer is automatically generated
How to bypass bank angle switch on 2006 goldwing