Battery Pack; Storage Recommendations; Package Contents - DeWalt DCT410 Original Instructions Manual

Eng lis h
WARNING: Burn hazard. Battery liquid
may be flammable if exposed to spark
or flame.

Battery pack

Battery type
The DCT410, DCT411 and DCT412 operate on
10.8 volt battery packs.

storage recommendations

1. The best storage place is one that is cool and
dry, away from direct sunlight and excess heat
or cold. For optimum battery performance and
life, store battery packs at room temperature
when not in use.
2. For long storage, it is recommended to store a
fully charged battery pack in a cool, dry place
out of the charger for optimal results.
NoTE: Battery packs should not be stored
completely depleted of charge. The battery pack will
need to be recharged before use.
labels on Charger and Battery pack
In addition to the pictographs used in this manual,
the labels on the charger and the battery pack show
the following pictographs:
Read instruction manual
before use.
Battery charging.
100%
Battery charged.
100%
Battery defective.
Hot/cold pack delay.
Do not probe with conductive objects.
Do not charge damaged battery packs.
Use only with D
others may burst, causing personal injury
and damage.
Do not expose to water.
8
WALT battery packs,
e
Have defective cords replaced
immediately.
Charge only between 4 ˚C and 40 ˚C.
Discard the battery pack with due care for
the environment.
Do not incinerate the battery pack.
See Technical data for charging time.
Only for indoor use.

package Contents

The package contains:
1 Inspection camera
1 Camera Cable 17 mm (DCT410)
1 Camera Cable 9 mm (DCT411)
1 Camera Cable 5.8 mm (DCT412)
1 Hook (DCT410, DCT411)
1 Magnet (DCT410, DCT411)
1 Mirror (DCT411)
1 Battery pack
1 Charger
1 Kit box
1 Instruction manual
1 Exploded drawing
NoTE: Battery packs and chargers are not included
with N-models.
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
description (fig. 2, 3)
WARNING: Never modify the inspection
camera or any part of it. Damage or
personal injury could result.
a. 10.8 V lithium ion battery
b. Camera with LED's
c. 0.9 m Camera cable
d. Camera connector