Questions And Answers; Trouble-Shooting Guide - Slendertone FLEX MAX Instruction Manual

Hide thumbs Also See for FLEX MAX:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1

Questions and Answers

Q
Can I use my
belt for post
SLENDERTONE
natal exercise?
A
Yes. If you are using your
unit for post
SLENDERTONE
natal toning, you should only begin the sessions a
minimum of six weeks after childbirth and you
must consult your doctor first. If you have had a
Caesarean in the past three months, you must
consult your doctor for approval before using the
belt.
SLENDERTONE
Q
How do I know when to replace the pads?
A
You may notice the signal is weakening even if the
batteries are OK. This usually indicates that the
pads are wearing and will soon need replacing. You
can check this by inserting new batteries and/or
adjusting the belt to ensure correct positioning. If
the pads are wearing, the
symbol will also
appear on the display. Replacement pads can be
purchased from your nearest
stockist,
SLENDERTONE
f rom the
website (www. s l e n d e rt o n e . c o m )
S LEND ERTO NE
or, by calling your local
Careline.
SLENDERTONE
Q
The pads are not sticking to the belt even though
they are fairly new. Is there any reason for this?
A
Ensure the patterned side of each pad is placed
onto the belt. The black side of the pads should
always be facing you. Press the edges of each
pad very firmly onto the belt before and after
each session.
Q
The stimulation is uncomfortable. How can I
improve this?
A
Ensure the pads are positioned correctly and that
they are pressed firmly against your skin. You can
check their placement by switching off your unit
and repositioning the belt as described on page 3.
You may also find it beneficial to rub a moisturiser
into the skin between sessions.
Q
I can feel a tingling sensation in my legs during
a session. What should I do?
A
Moving the two smaller pads upwards and inwards
on your waist (i.e. towards the centre of your body)
should prevent this.
8
Q
My skin is red after the session. Is this a problem?
A
Some redness of the skin after a
SLENDERTONE
session may occur. It is partly due to an increase in
the blood-flow under the skin and should fade
after the session. You may also experience some
reddening of the skin due to the pressure of the
stretched belt. This is the same as the pressure
marks you can get from wearing tight clothing. You
should not be concerned about this, but should
only wear the belt during a
session. If it
SLENDERTONE
is excessive, you may have the intensity too high,
which can increase the reddening on sensitive
skin. Try using the unit at a lower intensity for a
few days. You may also find it beneficial to rub a
moisturiser into the skin between sessions. If the
problem persists, you should stop using the unit.
Q
I can feel my waist muscles exercising but not my
stomach muscles.
A
Pause the programme and reposition the central
pad slightly lower on your stomach. If this doesn't
help, move the two small pads to a smaller figure
setting on the belt (towards the central pad).
Q
I can feel my stomach muscles exercising but not
my waist muscles.
A
Pause the programme and reposition the central
pad slightly higher on your stomach. If this doesn't
help, move the two small pads to a larger figure
setting on the belt (away from the central pad).
Q
Can I use my
belt to treat muscles
SLENDERTONE
weakened from lack of use due to injury?
A
Your
belt may additionally be used for
SLENDERTONE
the alleviation of or compensation for injury.
Consultation with your doctor is required to
establish a rehabilitation programme with the
unit, which would safely provide
SLENDERTONE
improvement to the strength and tone of the
abdominal muscles.

Trouble-Shooting Guide

Problem
Possible cause
The display doesn't come on &
The batteries are inserted
there is no signal from the unit
incorrectly
The batteries are dead
Low-quality batteries used
The display is on but there's
The unit has been paused
no signal
The battery symbol is flashing
The batteries are low
The contractions are very weak
The batteries are low
even when the intensity is high
The pads are worn
Poor pad positioning
Pads not covering studs
Low-quality batteries used
Unpleasant feeling beneath
The pads are worn
the pads
Pads not covering the studs
Too many consecutive sessions
Pads not in contact with skin
The
symbol has appeared on
Pads not covering metal studs
the display*
The pads are worn
The pads are on the wrong way
around
The covers are still on the pads
Unit is not fully inserted in holder
Belt is loose or open on body
E002/E003/E004 has appeared
Error message, indicating a problem
on the display
with the unit
Unintentional programme change
Accidental pressing of keys
during Ab Crunch programmes
* The
symbol always appears in conjunction with
the left/right arrows. If the left arrow appears, there
is a problem with the left pad, the right arrow indicates
Solution
Reposition the batteries as
described on page 3
Replace the batteries
Use only high-quality batteries
Press the on/off button briefly
Replace the batteries
Replace the batteries
Contact your local stockist for
new
abdominal
SLENDERTONE
replacement pads
See page 3 for the correct
positioning of the pads & belt
Reposition the pads
Use only high-quality batteries
Contact your local stockist for
new
abdominal
SLENDERTONE
replacement pads
Reposition the pads
You should leave at least six
hours between sessions
Reposition the belt
Reposition the pads
Contact your local stockist for
new
abdominal
SLENDERTONE
replacement pads
Ensure the black surface of the
pads are facing you
Ensure the covers are removed
from both sides of the pads
Reinsert the unit, see page 3 for
further details
Refasten belt, see page 3
for further details
See page 7 for further details
Activate intensity keylock. See
page 7 for further details.
a problem with the right pad and if both arrows appear,
there is a problem with either the middle pad or all
three pads.
9

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FLEX MAX and is the answer not in the manual?

Questions and answers

Table of Contents

Save PDF