Device Drivers; Windows Nt 4.0 - NEC Express5800 User Manual

Windows NT 4.0

The EXPRESSBUILDER "Express Setup" feature provides an automated installation
procedure for Windows NT 4.0. Refer to the EXPRESSBUILDER User's Guide
included on the EXPRESSBUILDER CDROM for information on running "Express
Setup."
This section of Appendix C contains instructions needed to manually install and
configure hardware and software used with the Microsoft Operating System Windows
NT Release 4.0. This information is intended to supplement the more detailed
procedural documents available from Microsoft. This information is not intended to be
the central source of installation and configuration information for your system. Read
this entire appendix along with Microsoft's Windows NT 4.0 installation procedures
before starting the installation process.
Note:
information before attempting to install Windows NT 4.0 Operating
System on your system.

Device Drivers

The drivers required for the devices listed in the table below are located on the
EXPRESSBUILDER CD. To create the required diskettes, select "Tools" on the
EXPRESSBUILDER CD. This table lists the required diskette labels.
Note:
make sure you use the drivers required for the devices on your specific system.
Always read the information in the release notes or inserts, included with any
options for they supersede the information in this guide.
Device
SCSI or SCSI RAID Controller
Network Controller
System Board
Video
*Diskette generated from the NEC EXPRESSBUILDER CDROM
**Run this application from the EXPRESSBUILDER CDROM; diskette not required
Read the System Release Notes for the latest system
When creating the required diskettes from the EXPRESSBUILDER CD
Required Driver Media*
Windows NT 4.0 OEM - Disk #1*
Windows NT 4.0 OEM - Disk #2*
Windows NT 4.0 NEC Update Module**
RAGE XL Driver for Windows NT 4.0**
Installing and Configuring Windows 2000 and Windows NT 4.0 C-7