NEC Express5800 User Manual page 101

Table 5-1. POST Error Codes and Messages (Continued)
Error code Error message
0B1C PCI Parity Error on
Bus/Device/Function.
0B30 Fan 1 Alarm occurred.
0B31 Fan 2 Alarm occurred.
0B22 Expansion Rom not initialized
0B50 CPU #1 with error taken off
line.
0B51 CPU #2 with error taken
offline.
0B5F Forced to use CPU with error
0B60 DIMM group #1 has been
disabled
0B61 DIMM group #2 has been
disabled
0B62 DIMM group #3 has been
disabled
0B63 DIMM group #4 has been
disabled
0B6F DIMM group with error is
enabled
0B70 The error occurred during
temperature sensor reading.
0B71 System Temperature out of the
range.
0B72 The error occurred during
voltage sensor reading.
0B75 System voltage out of the
range.
0B7C The error occurred during fan
sensor reading
Recommended Action
A fan failure or fan clogging may occur. Contact your service
representative to request the maintenance.
Check the PCI board installation. Or, disable the PCI board setting
not needed at start-up in [Advanced] → [Option ROM] of the SETUP
utility.
NOTES:
Do not disable the PCI device connected to the hard disk containing
the OS.
Do not disable the graphics device to which the monitor is connected.
Disable the Option ROM of PCI LAN device when network boot
feature is not used.
If the error persists, contact your sales representative to replace the
PCI board.
The CPU is degraded. Contact your service representative.
Because an error is detected in every CPU, the system is forcibly
started. Contact your service representative.
Contact your service representative.
Because an error is detected in every DIMM, the system is forcibly
started. Contact your service representative.
Contact your service representative.
A fan failure or fan clogging may occur. Contact your service
representative to request the maintenance.
Contact your service representative.
Problem Solving 5-15