NEC Express5800 User Manual page 102

Table 5-1. POST Error Codes and Messages (Continued
Error code Error message
0BB0 SMBIOS - SROM data read
error.
0BB1 SMBIOS - SROM data
checksum bad.
0BD0 1st SMBus device address not
acknowledged.
0BD1 1st SMBus device Error
detected.
0BD2 1st SMBus timeout.
0C00 RomPilot reports error number
xx
Expansion Rom not initialized
Invalid System Configuration
Data
System Configuration Data
Read Error
Resource Conflict
System Configuration Data
Write Error
WARNING: IRQ not configured
CPU#2
CPU#1
5-16 Problem Solving
Recommended Action
Contact your service representative.
Not a fatal error.
Turn off the power and then restart the server.
If an error persists, contact your service representative.
Turn off the power and then restart the server.
Or, start SETUP to verify the settings.
If an error persists, contact your service representative.
Change settings in [Advanced] → [Option ROM] of SETUP utility.
Contact your service representative.
DIMM#1
Figure 5-1. Component Locations
DIMM#2 DIMM#3 DIMM#4