Table of Contents
Advertisement
Item
Vector Scope
Enable
Target
Position
Test Pattern
62
OSD Menu
Setting Options (underline indicates factory default)
Vector Scope is displayed for SDI signals. Vector scope displays the intensity of color signals and
hue with the horizontal axis showing the color difference signal Cb and the vertical line showing Cr.
(Cb, Cr) = (0, 0)
Note
• "Vector Scope" is not displayed in the following cases:
-
When "Frame Hold" or "False Color" is "On",
-
When "Peaking 1" or "Peaking 2" is selected
-
During the execution of "Playback File" under "Screen Capture"
-
When a "Test Pattern" is displayed
-
When "H Delay"/"V Delay" is "On"
• When "Vector Scope" is "On", "Wave Form Monitor" is "Off".
Switches the vector scope On, Off.
On, Off
Sets the target.
75%, 100%
Selects the display position.
Bottom Left, Bottom Right
Sets the test pattern built into the main unit.
White, Gray (20%), Black, Red, Green, Blue, Ramp, 5 Step, Color Bars, PLUGE, Off
Note
• If the power is turned off once and then back on, the test pattern will not be displayed.
• The test pattern will be erased in the following cases:
-
When calibration has been started
-
When the channel is changed using the CH button, F button assigned for Channel UP/
Channel DOWN, or "Select Channel" under "Channel Settings"
-
When changing "Input Configuration" or "Select Input Signal" under "Channel Settings"
-
When "Reset All Settings" is executed
(Cb, Cr) = (255, 255)
Red
Magenta
Yellow
Cr
Green
Cyan
Cb
Blue
Advertisement
Table of Contents
