Expansion Module Installation - Motorola ET1 Integrator Manual

2 - 14 ET1 Enterprise Tablet Integrator Guide

Expansion Module Installation

To install the Scan Module or the Scan/MSR Module:
Power off the ET1.
1.
Remove the battery.
2.
If the handstrap is installed, rotate the handstrap to access the expansion module screws.
3.
Remove two screws using a T8 Torx
4.
Remove Screws Securing Module
Figure 2-15
Remove the existing module.
5.
Install the new module.
6.
Remove Module
Figure 2-16
Secure the two screws using a T8 Torx screwdriver.
7.
®
screwdriver.