Preparation - Panasonic ES-LV9N Operating Instructions Manual

Preparation

Charging the shaver
• Turn the shaver off.
• Wipe off any water droplets on the main body rear terminals.
1
Insert the appliance plug into
the self-cleaning recharger.
2
Remove the protective cap
while pressing the side of the
cap and insert the shaver into
the self-cleaning recharger.
• Slowly insert the shaver into the
self‑cleaning recharger taking care
not to damage the system outer foil.
3
Plug the adaptor into a household outlet.
• Check that the charge status lamp (
• Charging is completed after approx. 1 hour.
4
Disconnect the adaptor after charging is completed.
While charging
glows.
The number of the battery
capacity lamp will increase as
charging progresses.
8
2
3
1
) is glowing.
After charging is completed
The battery capacity lamp and
will light up and then turn
off after 5 seconds.
Notes
• When charging the shaver for the first time or when it has not
been in use for more than 6 months, the charging time may
change or the charge status lamp (
minutes. It will eventually glow if kept connected.
• Recommended ambient temperature for charging is 10 – 35 °C.
It may take longer to charge, or the charge status lamp (
blink quickly and the battery may fail to charge properly in
extremely high or low temperatures.
• The shaver can be used for approximately 2 weeks with a full
charge.
(Based on one 3‑minute dry‑shave use per day)
The number of usable days varies depending on the following
conditions.
- Beard thickness
- Pressure applied to the skin
- Ambient temperature
- Usage frequency of the sonic vibration cleaning mode
• If there is noise from radio or other source while using the
shaver, move to a different location to use the shaver.
) may not glow for a few
) will