Transport Instructions; Disposal; Appliance Setup; Electrical Connections - Blomberg BRFB 0900 Instruction Manual

en

Transport instructions

The device should be transported only in
upright position.
The packing as supplied must be intact
during transportation.
If refrigerator has been transported or
carried in the horizontal position, the
refrigerator may only be plugged in after
being in the vertical position for 4 hours.
Plugging in the refrigerator any sooner may
result in damage to the refrigerator and
affect your warranty.

Disposal

Make the device unusable immediately. Pull
out the mains plug and cut the power cable.
Remove or destroy snap or latch locks
before disposing of the device. In this
manner you prevent children from locking
themselves in and endangering their lives.

Appliance setup

• Do not operate your appliance in a room
where the temperature is likely to fall below
10 °C at night and/or especially in winter. At
lower temperatures the appliance may not
operate, resulting in a reduction in the
storage life of the food.
• The climate class rate of your appliance is
given on the rating label located inside the
appliance. It specifies the appropriate
operating ambient temperatures as
explained below.
Climatic class Ambient temperatures
SN.......................+10 °C to 32 °C
N.........................+16 °C to 32 °C
ST.......................+18 °C to 38 °C
T..........................+18 °C to 43 °C
SN-ST.................+10 °C to 38 °C
SN-T...................+10 °C to 43 °C
Location
Only place the device in dry rooms which
can be aired.
Avoid direct sunlight or direct heat sources
such as a stove or a heater.
If this cannot be avoided, the following
minimum distances should be maintained:
Electric stoves:
Heater:
Cooling devices: 2,50 cm
• Ensure sufficient air circulation for your
device.
• Make sure that sufficient room is provided
around the appliance to ensure free air
circulation.
• The device should be located on a smooth
surface. The two front feet can be adjusted
as required. To ensure that your appliance is
standing upright adjust the two front feet by
turning clockwise or counter-clockwise, until
the product is in firm contact with the floor.
Correct adjustment of feet avoids excessive
vibration and noise.

Electrical connections

Warning
This appliance must be grounded.
• Check whether the power type and voltage
your region corresponds to the one stated
on the rating label inside the appliance.
• The electrical safety of the appliance is
only assured when the grounding system in
the house is installed in accordance with
regulations.
• When placing the appliance, do not let the
power cable get stuck under it; otherwise the
cable will be damaged.
• Ensure that the plug remains readily
accessible. Do not use a multiple adapter
bar or an extension cable.
• The electrical specifications of your
appliance is given on the rating label located
inside the appliance.
• Route power cable to allow easy
connection and disconnection after
installation.
• A contact separator should be used if the
power cable is not accessible. (for built-in
models)
• We do not recommend use of extension
cord.
2
3,00 cm
3,00 cm
en