Extension Cords - DeWalt D26676-XE Instruction Manual

• Young children and the infirm. This appliance is not intended for use by
young children or infirm persons without supervision. Young children should be
supervised to ensure that they do not play with this appliance.
• Replacement of the supply cord. If the supply cord is damaged, it must be
replaced by the manufacturer or an authorised D
to avoid a hazard.

Extension Cords

CAUTION: Use only extension cords that are approved by the country's Electrical
Authority. Before using extension cords, inspect them for loose or exposed wires,
damaged insulation and defective fittings. Replace the cord if necessary.
MINIMUM GAUGE FOR CORD SETS
For Cable length (m): 7.5 15
Use Cable with minimum rating (Amperes)
Tool Amperes
0 - 3.4 7.5 7.5
3.5 - 5.0 7.5 7.5
5.1 - 7.0 10 10
7.1 - 12.0 15 15
12.1 - 20.0 20 20
WARNING: ALWAYS use safety glasses. Everyday eyeglasses are NOT safety
glasses. Also use face or dust mask if cutting operation is dusty. ALWAYS WEAR
CERTIFIED SAFETY EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CSA Z94.3),
• ANSI S12.6 (S3.19) hearing protection,
• NIOSH/OSHA/MSHA respiratory protection.
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and
other construction activities contains chemicals known to cause cancer, birth defects
or other reproductive harm. Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products, and
• arsenic and chromium from chemically-treated lumber (CCA).
Your risk from these exposures varies, depending on how often you do this type of
work. To reduce your exposure to these chemicals: work in a well ventilated area, and
work with approved safety equipment, such as those dust masks that are specially
designed to filter out microscopic particles.
WALT Service Centre in order
E
serious and permanent respiratory or other injury. Always use NIOSH/OSHA approved
respiratory protection appropriate for the dust exposure. Direct particles away from
face and body.
25 30 45 60
ANSI S12.6 (S3.19) during use. Under some conditions and duration of use, noise
from this product may contribute to hearing loss.
7.5 7.5 7.5 7.5
7.5 7.5 10 15
protection that conforms to ANSI Z87.1.
10 10 15 15
15 15 20 20
20 20 25 –
3
• Avoid prolonged contact with dust from power sanding, sawing, grinding,
drilling, and other construction activities. Wear protective clothing and wash
exposed areas with soap and water. Allowing dust to get into your mouth, eyes,
or lay on the skin may promote absorption of harmful chemicals.
WARNING: Use of this tool can generate and/or disburse dust, which may cause
WARNING: ALWAYS wear proper personal hearing protection that conforms to
WARNING: Always use eye protection. All users and bystanders must wear eye
• The label on your tool may include the following symbols. The symbols and their
definitions are as follows:
V .................... volts
Hz .................. hertz
min ................ minutes
........... direct current
................. Class I Construction
...................... (grounded)
................. Class II Construction
...................... (double insulated)
.../min ........... per minute
SAVE THESE INSTRUCTIONS FOR FUTURE USE
A ...............amperes
W ..............watts
...........alternating current
...........alternating or direct current
n o ..............no load speed
.............earthing terminal
.............safety alert symbol
BPM ..........beats per minute
RPM ..........revolutions per minute