Fixed Type - Yamaha JW-II Service Manual

Installation: Procedure
1. Remove the wheel from the wheelchair.
2. Remove the tilt lock assembly that is tenta-
tively tightened on the
NOTE:
Place the tilt lock assembly in order to recognize
which is right and left.
3. Insert the axle of the
into the axle hole of the wheelchair.
4. Place the plain washer (small) on the axle.
Then mount the tilt lock assembly and place
the plain washer (large) followed by the U
nut.
NOTE:
Place the plain washer (small) so it will fit inside
the tilt lock assembly installation hole. (Be care-
ful that they do not overlap)
5. The following section describes the same
procedure with the detachable type.
14

Fixed Type

wheel assembly.
wheel assembly