Installation: Procedure; Detachable Type - Yamaha JW-II Service Manual

Installation: Procedure

Tilt lock assembly
1. Remove the wheel and bolt clamp bracket
from the wheelchair.
2. Remove the tilt lock assembly which is ten-
tatively installed on the
bly.
NOTE:
Place the tilt lock assembly in order to recognize
which is right and left.
3. Install the bolt clamp bracket of the
the wheelchair frame.
NOTE:
Place the bolt head portion from the frame
outside.
4. Insert the tilt lock into the bolt clamp bracket
and apply the washer and nut. Then tighten
them tentatively.
NOTE:
The tilt lock has a longitudinal hole in it. As a
standard, the upper end of the hole should be
used.
5. Install the fitting spacer on the clamp
bracket.
NOTE:
Select a spacer which fits the pipe diameter of
the frame.
11

Detachable Type

wheel assem-
on