Wiring Connections; Removing/Reinstalling The Service Cover; Cables - Mitsubishi Electric AE-200A Installation Manual

7. Wiring connections

7-1. Removing/reinstalling the service cover

Unscrew the fixing screw on the service cover and unhook the hooks to remove it as shown in the figure below.
To replace the service cover, hook the hooks and screw the fixing screw back in.
Note
● When routing the cables from the bottom, cut out the knockout holes, cut a slit in the supplied rubber bushings to insert the
cables without the gap, and attach the bushings to the knockout holes.
● If the wall is 10 mm (13/32 in) or thicker, route the cables from the cable holes on the back.
Cable hole for power cables
Knockout hole for
power cables
WT07137X02
Service cover
Hook
Fixing screw (M3 × 6)
27
Cable hole for M-NET transmission cables
Knockout hole for M-NET transmission

cables