The Status Indicator - Mitsubishi Electric C10 SERIES Owner's Manual

TV Controls, continued
TV Control Panel
Buttons on the control panel duplicate some keys on
the remote control.
• Refer to lower labels when using TV menus or after
activating a special function.
• Refer to upper labels when no TV menus are dis-
played.
• SYSTEM RESET. If the TV does not respond to the
remote control, control-panel buttons, or will not
power on/off, press and hold the POWER button on
the control panel for ten seconds.

The STATUS Indicator

Key Off
Slow Blinking
LED Color TV Condition
TV is powered off. Normal operation.
None
TV is powered on. Normal operation.
Green
TV powered off, auto-on TV Timer is set.
Green
Normal operation. TV can be turned on at any time.
TV just powered off and lamp is cooling.
Green
Sixty seconds after turning off TV, LED will start to blink. TV can be turned back on before blinking
starts or after blinking stops, but not while the indicator is blinking. Normal operation.
TV is too hot. The TV will shut off if it overheats.
Amber
• Ambient room temperature may be too high. Turn off the TV and let the room temperature drop.
• Clear blocked air vents. Ensure at least a four-inch clearance on all sides of the TV.
Lamp access door is not secure or no lamp installed.
Amber
TV will not operate until lamp access door is secured. See Appendix A .
Lamp failure. Replace the lamp. See Appendix A .
Red
TV may require service.
Red/
• Hold power button on front panel for 10 seconds to reset TV.
Amber
• If LED continues to flash red and amber after reset, turn off the TV and unplug it from the AC
power source. Wait one minute and then plug the set back in.
• If LED continues to flash red and amber,
receive Authorized Service Center information.
You may be asked to count how many times the LED flashes each color to aid in troubleshooting.
Steady On
Fast Blinking
1. Setup and Operation
65" or 73" TV: Open
cover to use buttons
on the front panel.
Typical
control
panel.
go to www.mitsubishi-tv.com or call 1-800-332-2119 to
For assistance call 1(800) 332-2119
POWER
STATUS
INPUT
7