Mitsubishi Electric C10 SERIES Owner's Manual page 32

32
Appendices
Appendix B: Troubleshooting, continued
TV Power On/Off
Symptom
1. TV takes an excessively long
time to power on.
2. You cannot program the TV to
turn on automatically (Timer
function)
3. TV turned itself off.
4. TV will not power off.
Picture
Symptom
1. Picture does not look like a
high-definition picture.
2. TV has sound but no picture.
3. Picture has become dimmer.
4. Picture from an HDMI input is
noisy (poor quality).
5. The image from a computer
appears distorted when viewed
on the TV.
For assistance call 1(800) 332-2119
Remarks
When powered on, the TV needs time to boot up, just as a computer does.
Also, the TV's lamp requires a few moments to heat up to full brightness.
• The TV may be locked.
• The clock may not be set.
Green light on the front panel is blinking
• Momentary power fluctuation caused the TV to turn off to prevent
damage. Wait for the green light to stop flashing and turn the TV on again.
• If the TV does not stay on, press the
for at least eight seconds to perform System Reset. If this happens fre-
quently, obtain an AC line power conditioner/surge protector.
• An unusual digital signal may have been received, triggering a protection circuit.
Wait for the light to stop flashing and turn TV on.
Amber light on the front panel is lit
• Internal TV temperature has exceeded proper levels. Cool the room.
• The TV has overheated. Clear blocked air vents and ensure at least four
inches of clearance on all sides of the TV.
Press the POWER button on the control panel for ten seconds to perform
System Reset.
Remarks
Not all signals are high-definition signals. To receive high-definition pro-
gramming from your cable or satellite provider, you must subscribe to the
provider's high-definition service. Some over-the-air broadcasts are in
high-defi nition and can be received with a high-quality antenna suited to your
location.
• Check that all video inputs are plugged in firmly.
• Press and hold the POWER button on the control panel for ten seconds to
perform System Reset.
• The lamp is nearing the end of its life. Order a new lamp.
• Adjust picture brightness and contrast to maximum levels.
Upgrade a Category 1 (unmarked) HDMI cable to a high-speed HDMI cable.
• Normal TV operation. The TV does not correct distortion in the picture
from a computer because the correction process may cut off the edges
of the image.
• The picture shape may be wrong for the image. Press
POWER button on the control panel
FORMAT to change.