Fuses - Can-Am Outlander 500 2008 Operator's Manual

Removal
Disconnect BLACK (-) cable first then
RED (+) cable.
WARNING
Always respect this order for dis-
assembly; disconnect BLACK (-)
cable first.
Remove the holding strap then pull the
battery out of frame.
vmo2006-007-025_a
1. Battery
2. Holding strap
Cleaning
Clean battery, battery casing and bat-
tery posts using a solution of baking
soda and water.
Remove corrosion from battery cable
terminals and battery posts using a
firm wire brush. Battery casing should
be cleaned by soft brush and baking
soda solution.
Installation
Reinstall battery in vehicle.
WARNING
Connect RED (+) cable first then
BLACK (-) cable. Always connect
RED (+) cable first.

Fuses

Always turn the ignition switch to
OFF position before replacing a de-
fective fuse.
If a fuse is damaged, replace it by one
of the same rating.
CAUTION: Do not use a higher rat-
ed fuse as this can cause severe
damage.
Fuses are located in the front service
compartment and at the rear near bat-
tery.
vmo2006-007-012_a
FRONT — FUSES LOCATION
1. (F1) Ignition coils (5 A)
2. (F2) Fan (20 A)
3. (F3) Fuel injectors (5 A)
4. (F4) Speedometer/speed sensor/tail lamp
(7.5 A)
5. (F5) Fuel pump (7.5 A)
6. (F6) Engine Control Module (ECM) (5 A)
7. (F7) Accessories (20 A)
_____________________
WARNING
119