Operation Check - Sharp MX-4110N Installation Manual

9) Pass the SATA harness through the saddle and wind it one
time and connect it to the RAID PWB of the mirroring unit.
Pass the SATA harness through the saddle and wind it three
times and connect it to the MFP control PWB.
C. Reattach the control PWB and the right rear
cabinet.
• If the fax box unit is installed, carry out steps 1), 2), and 3)
additionally.
1) Connect the interface cable to the control PWB unit.
2) Push the interface cable into the recessed portion of the sheet
metal on the control PWB unit.
3) Attach the snap band to the sheet metal of the control PWB
unit.
4) Push the control PWB unit into the main unit.
5) Secure the unit with the two screws.
6)
7)
8)
9)
• Reconnect the cables that have been removed in step A to the
original positions of the control PWB unit.
D. Turn ON the power of the main unit
1)
2)
4.
1)
2)
3)
Mirroring kit installed
Mirroring kit/HDD trouble
Mirroring kit/Rebuilding
MX-5111N MX-EB12 (MIRRORING KIT) 29 – 3
Fit the interface cable into the right rear cabinet cover.
Attach the right rear cabinet cover to the main unit.
At this time, check that the four hooks are properly fitted to the
main unit.
Secure the right rear cabinet with the screw.
Hook 1 Hook 2
7
8
Attach the ozone filter cover to the main unit.
Turn on the main power switch and the operation panel power
switch.
Date copying from the standard HDD to the mirroring unit HDD
is started. It is called "Rebuilding."
Check to confirm that the machine is booted.
It takes about one hour to complete rebuilding. Do not turn off
the power during rebuilding. When, however, the power is
turned off during rebuilding, turn on the power again, and
rebuilding will be continued. During rebuilding, a message is
displayed to indicate the operation. A job can be performed
during rebuilding, though the job speed may be reduced.

Operation check

Check to confirm that the mirroring kit active icon is displayed.
Use SIM62-20 to check to confirm that the HDD status is
REBUILDING/OK.
Perform copying and check to confirm that machine is normally
operating.
Hook 3
Hook 4
6