Table of Contents
Advertisement
8.3 Setting up Limit Values by Inputting Values
1
Starting the limit function
L.
5Ei
Continuous pressing
Key released
[L
Set [ key.
5 Eh] is
Press and hold down the
Release the key when
displayed.
The currently set lower-limit value
flashes.
2
Opening the value input screen
Press the | Zero/Tare | key.
All the digits are displayed, with the one
on the right end flashing.
This flashing
digit is the one that can be changed.
3
Entering a value
Press the | Zero/Tare | key again.
Pressing the key repeatedly changes
the flashing value until the desired
number is entered.
D
4
Selecting a digit
Press the | Function | key.
•*>
The flashing moves to the digit on the
immediate left.
Each time the key is
pressed, the flashing digit moves one
position left.
When the leftmost digit is
selected, the flashing advances to the
rightmost digit position.
5
Repeat Steps 3 and 4
\ I /
Enter the lower-limit value by selecting a
value with the
Zero/Tare
key and
moving the digits with the | Function
key, as needed.
1
6
Saving the lower-limit value
Press the | Memory | key.
After saving the lower-limit value, the
balance displays it briefly and proceeds
to the next setup.
>>Kl f one-point setup was chosen, the
setup is complete.
7
Setting up the upper-limit value
H. S f f c
\ \ I / /
The display changes to [H.
b h t ],
indicating that the upper-limit value can
be set.
If there is an upper-limit value already
set, that value will flash.
25
Advertisement
Table of Contents
